Part Number Hot Search : 
2SC2714 4C28BMR A3101 025NL 2SK3053 TD3FHL40 AN2966 025NL
Product Description
Full Text Search
 

To Download SL6310C Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 THIS DOCUMENT IS FOR MAINTENANCE PURPOSES ONLY AND IS NOT RECOMMENDED FOR NEW DESIGNS
DS 3302 -1
SL6310C
500mW SWITCHABLE AUDIO AMPLIFIER/OP AMP
The SL6310C is a low power audio amplifier which can be switched off by applying a mute signal to the appropriate pin. Despite the low quiescent current consumption of 5mA (only 0.6mA when muted) a minimum output power of 400mW is available into an 8 load from a 9V supply.
NON INV. INPUT INV. INPUT EARTH
1 2 SL6310 3 4
8 7 6 5
MUTE "B" MUTE "A" NC VCC
FEATURES
Can be Muted with High or Low State inputs Operational Amplifier Configuration Works Over Wide Voltage Range
OUTPUT
MP8 DG8 DP8
Fig. 1 Pin connections, SL6310 - (top view)
APPLICATIONS
Audio Amplifier for Portable Receivers Power Op. Amp High Level Active Filter
R1 220k V MUTE B MUTE A 100 CC
8
7 + -
6
5
QUICK REFERENCE DATA
INPUT
100n
1
2
3
4 OUTPUT R4 120k 100 8 LOAD
Supply Voltage: 4.5V to 13.6V Voltage Gain: 70dB Output into 8 on 9V Supply : 400mW (min.)
R2 220k
220n R3 4.7k 1 EARTH
ABSOLUTE MAXIMUM RATINGS
Supply voltage: 15V Storage temperature: --55C to + 125C
Fig. 2 SL6310 Test Circuit
SL6310C
ELECTRICAL CHARACTERISTICS
Test conditions (unless otherwise stated): Supply voltage Vcc: 7V Ambient temperature: -30C to +85C Mute facility : Pins 7 and 8 open circuit frequency = 1kHz Value Characteristics Min. Supply current Supply current mute (A) Supply current mute (B) Input offset voltage Input offset current Input bias current (Note 1) Voltage gain Input voltage range CMRR Output power THD NOTE 1. The input bias current flows out of pins 1 and 2 due to PNP input stage 40 400 40 Typ. 5.0 0.55 0.6 2 50 0.2 70 2.1 10.6 60 500 0.4 3 Max. 7.5 1 0.9 20 500 1 mA mA mA mV nA A dB V V dB mW % VCC = 4.5V VCC = 13V RS 10K RL = 8 POUT = 400mW, Gain = 28dB Pin 7 via 470k to earth Pin 8 = VCC RS 10k Units Conditions
Fig. 3 SL6310 lamp driver
Fig. 4 SL6310 servo amplifier
OPERATING NOTES
Mute facility The SL6310 has two mute control pins to allow easy interfacing to inputs of high or low levels. Mute control `A', pin 7, is left open circuit or connected to a voltage within 0.65 volt of Vcc (via a 100k resistor) for normal operation. When the voltage on pin 7 is reduced to within 1 volt of earth (via a 100k resistor) the SL6310 is muted Audio amplifier AstheSL6310 is an operational amplifier it is easy to obtain the voltage gain and frequency response required. To keep the input impedance high it is wise to feed the signal to the noninverting input as shown in Fig.2. In this example the input impedance is approximately 100k. The voltage gain is determined by the ratio (R3 + R4)/R3 and should be between 3 and 30 for best results. The capacitor in series with R3, together with the input and output coupling capacitors, determines the low frequency rolloff point. The upper frequency limit is set by the device but can be restricted by connecting a capacitor across R4. Operational amplifier It is impossible to list all the application possibilities in a single data sheet but the SL6310 offers considerable advantages over conventional devices in high output current applications such as lamp drivers (Fig.3) and servo amplifiers (Fig.4) . Buffer and output stages for signal generators are another possibility together with active filter sections requiring high output current.
SL6310C
80
74
72 60 GAIN (dB) GAIN (dB) 40 20 100 1k 10k 100k
70
68
66
64
62 4 8 12 VOLTAGE (V) 10
FREQUENCY (Hz)
Fig. 5 Gain v. frequency
Fig. 6 Gain v. supply voltage
1500 NON - MUTED CURRENT IN MUTED STATE (A)
6 CURRENT IN NON - MUTED STATE (mA)
1.2
4 OUTPUT POWER (W) 0.8
LOAD
1000 MUTE B MUTE A
4
8 LOAD
500
2
0.4 16 LOAD
0 0
MUTE B : PIN 8 TO SUPPLY MUTE A : PIN 7 TO EARTH BY 100k RESISTOR
4 VOLTAGE (V)
8
0 12
0 0 4 VOLTAGE (V) 8 12
Fig. 7 Supply current v. supply voltage
Fig. 8 Output power v. supply voltage at 5% (max) distortion


▲Up To Search▲   

 
Price & Availability of SL6310C

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X